NAME
kill - send signal to a process
SYNOPSIS
#include
#include
int kill(pid_t pid, int sig)
DESCRIPTION
Kill
sends the signal sig
to a process, specified by the process number
pid.
Sig
may be one of the signals specified in
sigaction(2)
or it may be 0, in which case
error checking is performed but no
signal is actually sent.
This can be used to check the validity of
pid.
The sending and receiving processes must
have the same effective user ID, otherwise
this call is restricted to the super-user.
If the process number is 0,
the signal is sent to all processes in the
sender's process group.
If the process number is -1
and the user is the super-user,
the signal is broadcast universally
except to
init
and the process sending the signal.
If the process number is -1
and the user is not the super-user,
the signal is broadcast universally to
all processes with the same uid as the user
except the process sending the signal.
No error is returned if any process could be signaled.
If the process number is negative but not -1,
the signal is sent to all processes whose process group ID
is equal to the absolute value of the process number.
Processes may send signals to themselves.
RETURN VALUE
Upon successful completion, a value of 0 is returned.
Otherwise, a value of -1 is returned and
errno
is set to indicate the error.
ERRORS
Kill
will fail and no signal will be sent if any of the following
occur:
-
[EINVAL]
-
Sig is not a valid signal number.
-
[ESRCH]
-
No process can be found corresponding to that specified by pid.
-
[ESRCH]
-
The process id was given as 0
but the sending process does not have a process group.
-
[EPERM]
-
The sending process is not the super-user and its effective
user id does not match the effective user-id of the receiving process.
When signaling a process group, this error was returned if any members
of the group could not be signaled.
SEE ALSO
getpid(2)
getpgrp(2)
sigaction(2)
raise(3)